Installing The Handle; Assembly - Toro 30317 Operator's Manual

Figure 3
1. Center Gage Wheels and
Spacer
2. Nut
3. Large washer-discard
2. Install the center gage wheels with the
previously removed bolt, spacer, small washer,
and nut (Figure 4).
Figure 4
1. Center Gage Wheels and
Spacer
2. Nut
3. Bolt
3. Remove the hairpin cotter and washer on both
front height-of-cut posts (Figure 5). Discard
the washers, these are not to be used for
adjusting the height-of-cut.
4. Angle bracket-discard
5. Small washer
4. Washer
5. Spacer
1. Hairpin cotter
2. Shipping washer
Step
2

Installing the Handle

Assembly

Parts needed for this step:
1 Handle assembly
4 Flanged bolt, 3/8 x 1 inch
4 Flange nut, 3/8 inch
Procedure
1. Align handle with upper mounting holes in
rear frame (Figure 6).
2. Secure the handle at each upper mounting hole
with a flange bolt (3/8 x 1 inch) and flange nut
(Figure 6).
3. Select the low position for the lower mounting
hole (Figure 6).
4. Secure the handle at each lower mounting hole
with a flange bolt (3/8 x 1 inch) and flange nut
(Figure 6).
Note: The handle position can be adjusted to
match the operator's height preference.
13
Figure 5
3. Height-of-cut post
4. Mower