Figure 25
1. Control rod and tting
2. Idler bracket
3. Clevis pin
2. Loosen the upper flange bolts (3/8 x 1 inch)
and flange nut securing handle to rear frame
(Figure 26).
Figure 26
1. Upper handle
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
3. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 26).
4. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch) and
flange nuts into mounting holes. Tighten all
flange bolts.
5. Thread rod fitting up or down on rod until
proper position is attained and install into
4. Washer
5. Hairpin cotter pin
6. Rod tting
5. Upper mounting hole
6. Lower mounting holes
7. Low position
8. High position
fitting to idler bracket with clevis pin, washer
and hairpin cotter. Refer to Installing the
Control Rods in Setup, page 12.
6. Check the parking brake adjustment. Refer to
Checking the Brakes in Brake Maintenance,
page 37.
27