Adjusting The Center Gage; Wheels; Adjusting The Handle Height - Toro 30317 Operator's Manual

Figure 22
1. Mower
3. Add or remove spacers if needed and then
align holes and insert hairpin cotter (Figure 23).
Note: Spare height-of-cut spacers may be
stored on posts and retained by a hairpin cotter.
Important: All four hairpin cotter pins
must be in the same hole location and with
the correct number of spacers for a level
cut.
Figure 23
1. Carrier Frame
2. Hairpin Cotter
3. Front height-of-cut post
2. Lift handle
4. Spacers
5. Back height-of-cut post

Adjusting the Center Gage

Wheels

The gage wheels need to be adjusted in the proper
hole location for each height-of-cut position.
There needs to be 3/8 inch (10 mm) minimum
clearance above the ground.
1. After adjusting height-of-cut, check the gage
wheels so that there is a minimum of 3/8
inch (10 mm) clearance above the ground
(Figure 24).
2. If adjustment is needed, remove the bolt,
washers and nut (Figure 24).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Figure 24).
4. Install the bolt, washers and nut (Figure 24).
Figure 24
1. Center Gage Wheels and
Spacer
2. Nut
3. Bolt

Adjusting the Handle Height

The handle position can be adjusted to match the
operator's height preference.
1. Remove hairpin cotter, washer and clevis pin
securing control rod fitting to idler bracket
(Figure 25).
26
4. Washer
5. Spacer