Changing The Deck Front-To-Rear; Pitch; Checking The Deck Side-To-Side - Toro 30317 Operator's Manual

Figure 62
Figure 63
Changing the Deck
Front-to-Rear Pitch
Changing the front-to-rear pitch is done by
adjusting the front height-of-cut posts.
1. To change the front-to-rear pitch, the front
height-of-cut posts can be adjusted (Figure 64).
Figure 64
1. Caster Wheel
2. Carrier Frame
3. Front height-of-cut pins
2. To raise the front of the deck, loosen jam nut
and rotate the front pin clockwise (Figure 64).
3. To lower the front of the deck, loosen jam
nut and rotate the front pin counter clockwise
(Figure 64).
4. Position the blades front-to-rear. Measure at
C and D locations (Figure 62) from a level
surface to the cutting edge of the blades.
5. Check the side-to-side leveling of the cutting
unit.
6. Tighten the jam nuts (Figure 64).
Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and
traction unit.
2. Position the blades side-to-side (Figure 65).
Measure at A and B locations (Figure 65) from
a level surface to the cutting edge of blade tips
(Figure 66).
45
4. Jam nut
5. Ball joint