Atv Immersion; Post-Operation Care; Storage And Preseason Preparation - BOMBARDIER DS650 Operator's Manual

On the LH side, remove the oil inlet hose on
the engine.
V02C4DY
1. Oil inlet hose
WARNING
The engine and the engine oil can be very
hot. Wait until engine or engine oil has
cooled off.
Lower oil inlet hose until a little quantity of oil
flows without air bubbles.
Replace oil inlet hose and tighten clamp prop-
erly.
Check oil level in oil tank and refill if neces-
sary.
Start engine. If RED engine indicator lamp
stays ON, stop engine and see an authorized
Bombardier ATV dealer as soon as possible.

ATV Immersion

Should the ATV become immersed, it will be
necessary to take it to an authorized
Bombardier ATV dealer as soon as possible.
DO NOT START THE ENGINE!
CAUTION: Immersion of the ATV can cause
serious damage if the correct restart proce-
dure is not followed.
80
1

Post-Operation Care

When vehicle is used in salt-water environ-
ment (beach area, launching/loading boats,
etc.), rinsing the vehicle with fresh water is
necessary to preserve vehicle and its compo-
nents. Metallic parts lubrication is highly rec-
ommended. Use BOMBARDIER LUBE
(P/N 293 600 016) or an equivalent. This
must be performed at the end of each operat-
ing day.
When vehicle is operated in muddy condi-
tions, rinsing the vehicle is recommended to
preserve vehicle and its components and to
keep lights clean.
NOTE: Never use a high pressure washer to
clean the vehicle. USE LOW PRESSURE
ONLY (like a garden hose). The high pressure
can cause electrical or mechanical damages.
Storage and Preseason
Preparation
WARNING
Have an authorized Bombardier ATV
dealer inspect fuel system integrity as
specified in MAINTENANCE CHART.
When a vehicle is not in use for more than one
month, proper storage is a necessity.
See an authorized Bombardier ATV dealer for
proper procedures.
When using your ATV after storage, a prepa-
ration is requ ired. See an authorized
Bombardier ATV dealer for proper proce-
dures.