Atv Immersion; Post-Operation Care; Storage And Preseason Preparation - BOMBARDIER DS650 2005 Operator's Manual

V02C4DY
1. Oil inlet hose
WARNING
The engine and the engine oil can
be very hot. Wait until engine or
engine oil has cooled off.
Lower oil inlet hose until a little quan-
tity of oil flows without air bubbles.
Replace oil inlet hose and tighten
clamp properly.
Check oil level in oil tank and refill if
necessary.
Start engine. If RED engine indicator
lamp stays ON, stop engine and see
an authorized Bombardier ATV dealer
as soon as possible.

ATV Immersion

Should the ATV become immersed, it
will be necessary to take it to an autho-
rized Bombardier ATV dealer as soon
as possible. DO NOT START THE
ENGINE!
CAUTION:
Immersion of the ATV
can cause serious damage if the
correct restart procedure is not fol-
lowed.
______________________
80
1

Post-Operation Care

When vehicle is used in salt-water
environment (beach area,
ing/loading boats, etc.), rinsing the
vehicle with fresh water is necessary
to preserve vehicle and its compo-
nents. Metallic parts lubrication is
highly recommended.
BARDIER LUBE (P/N 293 600 016)
or an equivalent. This must be per-
formed at the end of each operating
day.
When vehicle is operated in muddy
conditions, rinsing the vehicle is rec-
ommended to preserve vehicle and its
components and to keep lights clean.
NOTE:
Never use a high pressure
washer to clean the vehicle USE
LOW PRESSURE ONLY (like a gar-
den hose) . The high pressure can
cause electrical or mechanical dam-
ages.
Storage and Preseason
Preparation
WARNING
Have an authorized Bombardier
ATV dealer inspects fuel system
integrity as specified in MAINTE-
NANCE CHART.
When a vehicle is not in use for more
than one month, proper storage is a
necessity.
See an authorized Bombardier ATV
dealer for proper procedures.
When using your ATV after storage, a
preparation is required. See an autho-
rized Bombardier ATV dealer for proper
procedures.
launch-
Use BOM-