Throttle Lever Adjustment - BOMBARDIER DS650 Operator's Manual

Install the cable luber (P/N 529 035 738) or an
equivalent on the cable.
V00I03Y
Insert the needle of spray can in the cable lu-
ber hole.
WARNING
Always wear eye protection and gloves
when you lubricate a cable.
NOTE: Place a rag around the cable luber to
prevent the lubricant from splashing.
Put the lubricant until it passes through the
cable.
Reinstall the cable.
Spray a little quantity of lubricant on the throt-
tle lever mechanism then close the housing.
Adjust the throttle lever.

Throttle Lever Adjustment

Slide rubber protector back to expose throttle
cable adjuster.
Loosen lock nut then turn the adjuster to ob-
tain correct throttle lever free play.
NOTE: Measure throttle free play at the tip of
throttle lever.
Tighten lock nut and reinstall protector.
3 4
2
V02I04Y
1. Throttle lever
2. Protector
3. Cable adjuster
4. Lock nut
A. 3 to 8 mm (1/8 to 5/16 in)
Clutch Adjustment
Loosen cable tension by closing the cable ad-
juster on the clutch lever.
Adjust clutch release mechanism as follows.
The release lever must locate on the spline in
such a way that dimension A is obtained. See
the following illustration.
A
1
109