Note: this order is only valid for current channel.
Order syntax:STATus:OPERation:INSTrument:CONDition?
Return parameter:<parameter of operation condition register>
Example:STAT:OPER:INST:COND?
INSTrument[SELect]
This order can be used to select the channel.
Order syntax:INSTrument[:SELect]
Parameter:FIRst|SECOnd|THIrd
Reset value:FIRst
Example:INST SECO
INSTrument[:SELect]?
This order can check which channel is selected.
Order syntax:INSTrument[:SELect]?
Return parameter:FIRst|SECOnd|THIrd
Example:INST?
INSTrument:NSELect
This order is similar to the order "INSTrument[SELect]", the only difference is that this order uses
number to denote channel.
Order syntax:INSTrument:NSELect
Parameter:1~3
Reset value:1
Example:INST:NSEL?
OUTPut[:STATe]
This order can set the output state for current channel: ON/OFF
Order syntax:OUTPut[:STATe] <parameter>
Parameter:1(ON)|0(OFF)
Example:OUTP 1
OUTPut[:STATe]?
This order can check the output state for current channel: ON/OFF
Order syntax:OUTPut[:STATe]?
Return parameter:0|1
Example:OUTP?
OUTPut:TIMer:DATA
This order can set time of output-timer for current channel.
Order syntax:OUTPut:TIMer:DATA <parameter>
Parameter:0~999999S (if you set 0S,the output-timer will be disabled.)
Reset value:it is concerned about the parameter you set in the menu.
Example:OUTPut:TIMer:DATA 100
16
Need help?
Do you have a question about the IT6322 and is the answer not in the manual?