Accessing Measured Blood Pressure Values; Ecg Measurement; Preparing The Ecg Measurement - Beurer BM 95 Instructions For Use Manual

5.5 Accessing measured blood pressure values

The device has two user memories. Each user memory can store up to 60 measured values. Once
all memory spaces in a user memory have been used, the oldest measured values are replaced by
the most recent.
You can access stored measured values on the device at any time. Proceed as follows:
1. With the device switched off, press the memory button M. The last
stored measured value in the selected user memory is displayed.
To access the measured values in the second user memory,
press and hold the memory button M for 5 seconds.
2. To navigate between the individual measured values, press the mem-
ory button M.

6. ECG measurement

6.1 Preparing the ECG measurement

Observe the following before beginning the ECG measurement:
• Never use the ECG stick on top of clothing.
• If the electrode surfaces of the ECG stick are dirty, clean them with a cotton bud soaked in rub-
bing alcohol.
• If your skin or hands are dry, moisten them using a damp cloth before the measurement.
• Please note that there must be no skin contact between your right and left hand (measurement
method C) or hand and chest (measurement methods A/B). Otherwise, the measurement cannot
be taken correctly.
• Ensure that your right hand does not come into contact with your body during the measurement.
To ensure an accurate measurement, press only lightly on the upper and lower electrodes of the
ECG stick.
• Never use the ECG stick upside down.
• Do not speak or move while carrying out the ECG measurement as this can cause inaccuracies
during the measurement.
43
M