Toyota GRJ120L Installation Manual page 34

[6]
WATER PUMP PULLEY
[5]
P/S PUMP PULLEY
[3]
IDLE PULLEY
[4]
CRANK PULLEY
[2]
COMPRESSOR
[7]
WATER PUMP PULLEY
[6]
P/S PUMP PULLEY
[4]
IDLE PULLEY
[5]
CRANK PULLEY
[4]
IDLE PULLEY
B001222
[1]
ALTERNATOR
PULLEY
[3]
IDLE PULLEY
[2]
AUTO
TENSION
PULLEY
[3]
IDLE PULLEY
[3]
IDLE PULLEY
[7]
IDLER ASSY
(DISCARD)
[8] BOLT
(DISCARD)
[1]
BOLT
(M8 x 81)
[1] ALTERNATOR
PULLEY
[4]
IDLE PULLEY
[2]
AUTO
TENSION
PULLEY
[3]
COMPRESSOR PULLEY
(b) Temporarily remove the original drive belt.
NOTE
Remove the drive belt with turning the A/T pulley
counter-clockwise.
(c) Remove and discard the original idler and three
bolts.
B001221
(d) Install the compressor to the engine block using
four bolts.
Tightening Torque
24.5 N•m (250 kgf•cm, 18.1 ft•lbf)
BC2614
(e) Install the compressor drive belt. (Reuse)
- 29 -
00502437EA