Toyota GRJ120L Installation Manual page 14

CAUTION
[2] THERMISTOR
[4] FULL
CONTACT
[1] EVAPORATOR
[1] EVAPORATOR
B001172
[1] EVAPORATOR
[2] THERMISTOR
[2] THERMISTOR
#
50 5mm 50 5mm
[3] 5TH ROW
[1] EVAPORATOR
[2] THERMISTOR
[3]
PARALLEL
[2] THERMISTOR
[4] CLAMP
[5]
[1]
EVAPORATOR
[2]
UNDER COVER
(2) EVAPORATOR
(a) Insert the thermistor on the evaporator in the
position shown in the figure.
CAUTION
1. Insert the thermistor as far as it goes so that it is
in full contact with the evaporator.
2. To retain it securely, the thermistor is always
inserted into a position only once.
(Once it has been inserted into a location, do
not use that location again.)
3. When reusing the evaporator, shift the
B001171
thermistor either up or down 50
(The area marked with the # in the figure.)
4. After the thermistor is inserted, do not apply any
strong forces to the lead wire.
(b) Secure the marked portion of the thermistor with
a clamp to the evaporator, in the position shown
in the figure.
MARKED
PORTION
(c) Assemble the under cover to the evaporator.
B001173
- 9 -
00502437EA
±
5mm.