Mercury 300 - PRO MAX 3.0L User Manual page 56

Table of Contents

goh120

Fuel System (Continued)

WATER SEPARATING FUEL FILTER

NOTE: The warning system will turn on when water in the fuel filter

reaches the full level. Refer to "Warning System" in Features & Con-

trols Section.

This filter removes moisture and also debris from the fuel. If the

filter becomes filled with water, the water can be removed. If the

filter becomes plugged with debris, the filter must be replaced

with a new filter.

Remove and replace filter as follows:

•

Turn ignition key switch to OFF position.

•

Disconnect wire (a) at bottom of filter. Remove filter by turning the

filter in the direction of the arrow (clockwise). Tip the filter to drain

fluid in a suitable container.

•

Lubricate the sealing ring on the filter with oil. Thread on the filter

and tighten securely by hand. Reconnect the wire to the filter.

IMPORTANT: Visually inspect for fuel leakage from the filter by

squeezing the primer bulb until firm, forcing fuel into the filter.

MAINTENANCE

Table of Contents

Show Quick Links

Table of Contents