Checking The Boom Hinge; Springs - Toro 41177 Multi-Pro 1250 Operator's Manual

2. Install the monitor bracket on the dash
(Figure 5) using 2 flange-head bolts
(1/4 x 3/4 inch) and 2 flange nuts (1/4 inch).
Figure 5
1. Spray Pro monitor
2. Bracket
3. Loosely install the 2 carriage bolts, rubber
washers, and knobs on the bracket as illustrated
in Figure Figure 5 and Figure 6.
Note: Install the carriage bolts and rubber
washers inside of the bracket and the knobs
on the outside.
Figure 6
1. Carriage bolt
2. Rubber washer
4. Remove the large grommet from the hole in
the dash and thread the cables on the monitor
through the grommet and the dash.
5. Install the grommet into the dash.
3. Flange-head bolts,
1/4 x 3/4 inch
4. Knob
3. Knob
4. Bracket
6. Install the Spray Pro monitor over the carriage
bolt heads (Figure 5) and tighten the knobs to
secure it.
7. Connect the Spray Pro wire connectors to
the wire connectors located under the dash
(Figure 7).
1. Connectors from the
sprayer
Step
3

Checking the Boom Hinge

Springs

No Parts Required
Procedure
Important: Operating the spray system
with the boom hinge springs under the
incorrect compression could damage the
boom assembly. Measure the springs and use
the jam nut to compress the springs to 1.56
inches if necessary.
The sprayer is shipped with the boom extensions
swung forward to facilitate packaging of the
machine. The springs are not fully tightened at
15
Figure 7
2. Connectors from the
monitor