Calibrating The Spray Pro; Monitor - Toro 41177 Multi-Pro 1250 Operator's Manual

Calibrating the Spray Pro

Monitor

1. LCD screen
2. Selection dial
3. Total area
4. Speed
5. Units of measure
The Spray Pro monitor has a calibration mode that
allows you to change various settings to customize
the display and calibrate the monitor to your needs.
You can calibrate or change the following settings:
• Boom Width
• Units of Measure
• Speed
• Flowmeter
Setting the Boom Width
The default settings for the boom widths are 80
inches (2.03 m) for the right and left booms and
60 (1.524 m) for the center boom. This is based
on 4 nozzles on the right and left booms and 3 on
the center boom all spaced 20 inches (50.8 cm)
apart. If you change the spacing of the nozzles,
you should change the boom width to reflect your
changes as follows:
1. Stop the sprayer and set the parking brake.
2. Set the master boom switch to the Off
position. The monitor displays "HOLD".
Figure 29
6. Application rate
7. Distance
8. Sub Area
9. Sub volume
10. Total volume
11. Reset, calibration button
12. Calibrate, calibration button 17. Width
13. Decrease, calibration button 18. Speed calibration
14. Increase, calibration button 19. Flowmeter calibration
15. Boom selection
3. Press and hold the Calibrate button until the
monitor displays "CAL HOLD" and the red
light on the monitor illuminates.
4. Turn the selection dial to the Total Area
position.
5. Use the Increase or Decrease calibration
buttons to select the boom for which you wish
to change the width, where 1 is the left boom,
2 is the center boom, and 3 is the right boom.
6. Turn the selection dial to the Sub Area
position.
7. Use the Increase or Decrease calibration
buttons to change the boom width as needed.
8. Repeat steps 4 through 7 for the other booms
as needed.
9. Press the Calibrate button until the red light
turns off. You can also exit the calibration
mode by driving the sprayer.
33
16. Select units
20. LED