Table of Contents
Advertisement
Charging the battery produces gasses
that can explode.
Never smoke near the battery and keep
sparks and flames away from battery.
4. Install the battery in the chassis; refer to
Installing the Battery.
Storing the Battery
If the machine will be stored for more than
30 days, remove the battery and charge it fully.
Either store it on the shelf or on the machine.
Leave the cables disconnected if it is stored on the
machine. Store the battery in a cool atmosphere
to avoid quick deterioration of the charge in the
battery. To prevent the battery from freezing,
make sure it is fully charged.
Drive System
Maintenance
Maintaining the Primary
Drive Clutch
After every 400 operating hours or yearly, clean
and lubricate the clutch as follows:
1. Stop the engine, remove the key, and set the
parking brake.
2. Raise the front end of the sprayer and support
it on jack stands.
A sprayer on a jack may be unstable
and slip off of the jack, injuring anyone
beneath it.
• Do not start the engine while the
sprayer is on a jack.
• Always remove the key from the
ignition before getting off of the
sprayer.
• Block the tires when the sprayer is on
a jack.
3. Disconnect the hose located on the lower-front
face of the tank (Figure 57).
1
3
Figure 57
1. Clutch cover
2. Hose
4. Remove the 3 bolts securing the cover to the
clutch and remove the cover (Figure 58).
Note: You may need to push the heat shield
(Figure 57) back as you remove the cover.
Figure 58
1. Cover
The dust in the clutch will become
airborne and could damage your eyes or
you could inhale it causing breathing
difficulties.
Wear safety goggles and a dust mask
or other eye and respiratory protection
when performing this procedure.
5. Lubricate the moving parts in the areas circled
in Figure 59 using Toro Dry Lubricant Spray,
available through your Authorized Toro Dealer
or Distributor.
51
2
G001990
3. Heat shield
2. Bolts
Hide quick links:
Advertisement
Table of Contents
