Fuses; Drive System Maintenance; Torquing The Wheel Nuts; Adjusting The Traction Drive For Neutral - Toro 30809 Groundsmaster 3500-G Operator's Manual

WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.

Fuses

The fuses for the traction unit electrical system are located
under the console cover.
Drive System
Maintenance

Torquing the Wheel Nuts

Service Interval: After the first hour
After the first 10 hours
Every 200 hours
Torque the wheel nuts to 61 to 88 N-m (45 to 65 ft-lb).
WARNING
Failure to maintain proper torque of the wheel nuts
can result in personal injury.
Adjusting the Traction Drive
for Neutral
If the traction unit moves when the traction pedal is in the
neutral position, the traction cam must be adjusted.
1. Position the throttle lever rearward so it stops against
the control panel slot.
2. Loosen the throttle-cable connector on the
injection-pump lever arm
1. Injection-pump lever arm
3. Hold the injection-pump lever arm against the low idle
stop and tighten the cable connector.
4. Loosen the screws securing the throttle control to the
control panel.
5. Push the throttle-control lever all of the way forward.
6. Slide the stop plate until it contacts the throttle lever
and tighten the screws securing the throttle control to
the control panel.
7. If the throttle does not stay in position during
operation, tighten the locknut on the throttle-lever
friction device to 5 to 6 N-m (40 to 55 in-lb) The
40
(Figure 53).
Figure 53