Toro 30809 Groundsmaster 3500-G Operator's Manual page 48

3. Push the second bearing out in a press.
4. Inspect the roller housing, bearings, and bearing spacer
for damage (Figure 68). Replace damaged components
and assemble.
Assembling the Front Roller
1. Press the first bearing into the roller housing
68). Press on the outer race only or equally on the
inner and outer race.
2. Insert the spacer
3. Press the second bearing into the roller housing
68).Pressing equally on the inner and outer race until
the inner race comes in contact with the spacer.
4. Install the roller assembly into the deck frame.
5. Verify that there is no more than a 1.5 mm (0.060 inch)
gap between roller assembly and the roller mount
brackets of the deck frame. If there is a gap over 1.5
mm (0.060 inch), install enough 5/8 inch diameter
washers to take up the slop.
Important: Securing the roller assembly with a
gap larger than 1.5 mm (0.060 inch) creates a side
load on the bearing and can lead to premature
bearing failure
6. Tighten the mounting bolt to 108 N-m (80 ft-lb).
48
(Figure 68).
(Figure
(Figure