Product Overview; Controls - Toro 30809 Groundsmaster 3500-G Operator's Manual

Product Overview

Controls

Figure 16
1. Forward-traction pedal
2. Reverse-traction pedal
3. Mow/transport slide
Traction Pedals
Press the forward-traction pedal
Press the reverse-traction pedal
or to assist in stopping when moving forward. To stop the
traction unit, move the pedal to, or allow it to move to, the
neutral position.
Mow/Transport Slide
Using your heel to move the Mow/Transport slide
16) to the left to transport, and to the right to mow. The
cutting-units will only operate in the Mow position.
Note: The mowing speed of the machine is set at the factory
to 9.7 km/h (6 mph). The mowing speed can be increased or
decreased by adjusting the speed-stop screw
Figure 17
1. Speed-stop screw
4. Tilt-steering lever
5. Indicator slot
6. Angle indicator
(Figure 16) to move forward.
(Figure 16) to move backward
(Figure
(Figure 17).
Tilt-Steering Lever
Pull the tilt-steering lever
wheel to the desired position. Push the lever forward to lock
the steering wheel into position.
Indicator Slot
The slot in the operator platform
the cutting-units are in the center position.
Angle Indicator
The angle indicator (Figure
the machine in degrees.
Ignition Switch
Use the ignition switch
the engine. The 3 positions of the switch are; Off, On, and
Start. Rotate the key to the Start position to start the engine.
Release the key when the engine starts. The key automatically
moves to the On position when you release it. To shut the
engine off, rotate the key to the Off position. Remove the
key from the ignition to prevent someone from starting the
machine unintentionally.
1. Throttle
2. Hour meter
3. Temperature light
4. Oil pressure light
5. Check engine light
6. Alternator light
Throttle
Move the throttle (Figure
speed and rearward to decrease the engine speed.
PTO Switch
The PTO switch (Figure
In (stop). Pull the PTO switch out to engage the cutting-unit
blades. Push the switch in to disengage the cutting-unit blades.
17
(Figure 16) back to tilt the steering
(Figure 16) indicates when
16) indicates the side-hill angle of
(Figure 18) is used to start and stop
Figure 18
7. PTO switch
8. Cutting-unit shift lever
9. Ignition switch
10. Parking brake
11. Lift lever lock
18) forward to increase the engine
18) has 2 positions: Out (start) and
g021539