Engine Maintenance; Servicing The Air Cleaner - Toro 30809 Groundsmaster 3500-G Operator's Manual

•
Rear roller bearings (2 per cutting unit)
Figure 46
Note: Make sure that the grease groove in each roller
mount aligns with the grease hole in each end of the roller
shaft. To help align the groove and hole, there is also an
alignment mark on 1 end of the roller shaft.

Engine Maintenance

(Figure 46)

Servicing the Air Cleaner

Service Interval: Every 200 hours (More frequently in
Inspect the air cleaner and hoses periodically to maintain
G011349
maximum engine protection and to ensure maximum service
life. Check the air-cleaner body for damage, which could
cause an air leak. Replace a damaged air-cleaner body.
Inspect and change the air-cleaner filter as described in the
following procedure:
1. Pull the latch outward and rotate the air-cleaner cover
1. Air-cleaner cover
2. Before removing the filter, use low-pressure air (40 psi,
3. Remove and replace the primary filter.
4. Inspect the new filter for shipping damage, checking
5. Insert the new filter by applying pressure to the outer
36
extreme dusty or dirty conditions)
counterclockwise.
Figure 47
clean and dry) to help remove large accumulations of
debris packed between the outside of the primary filter
and the canister.
Important: Avoid using high-pressure air which
could force dirt through the filter into the intake
tract. This cleaning process prevents debris from
migrating into the intake when you remove the
primary filter.
Note: Cleaning of the used element is not
recommended due to the possibility of damage to the
filter media.
the sealing end of the filter and the body.
Important: Do not use a damaged filter.
rim of the element to seat it in the canister.
2. Filter