Engaging The Rotor Blades - Toro 38564 CCR 6053 Operator's Manual

Figure 14
1. Choke lever
Figure 15
1. Symbols on the choke lever indicating to move the choke
lever to the right to activate the choke.
3. Firmly push in the primer 3 times with your thumb,
holding the primer in a for a second before releasing it
each time (Figure 16).
Figure 16
Note: Remove your glove when you push in the
primer so that air cannot escape from the primer hole.
Important: Do not use the primer or the choke if
the engine has been running and is hot. Excessive
priming may flood the engine and prevent it from
starting.
4. Pull the recoil-start handle (Figure 17).
Note: If you pull the recoil handle and feel no
resistance, the starter may be frozen. Thaw out the
starter before attempting to start the machine.
5. While the engine is running, push in the choke lever
slowly.

Engaging the Rotor Blades

To engage the rotor blades, hold the control bar against the
handle (Figure 18).
1. Control bar
9
Figure 17
Figure 18