Setup; Unfolding The Handle; Installing The Discharge Chute - Toro 38564 CCR 6053 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1

Unfolding the Handle

No Parts Required
Procedure
1. Loosen the handle knobs, pull out the U-shaped handle
locks until you can move the handle freely, and rotate
the handle to the operating position (Figure 4).
1. U-shaped handle lock (2)
2. Insert the end of the U-shaped handle lock into the
open hole in the handle and tighten the handle knobs
until they are snug (Figure 5).
Description
No parts required
Discharge chute
Chute handle
Phillips-head bolts
Washers
Locknuts
G016242
Figure 4
2. Handle knobs
Qty.
–
Unfold the handle.
1
1
3 Install the discharge chute.
3
3
Important: Ensure that you do not pinch or kink
the control cable (Figure 6).
1. Control cable
5
Use
Figure 5
Figure 6