Advertisement
Propercare
and cleaning are
i.~p~~~n~ so
yOUr
range
will give
youefficientand satisfactory
service. Followthese directions
carefullyin caring for your range to
assuresafe and proper maintenance.
Finkhes
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid-resistant.
However,any acid foods spilled
(such as fruit juices, tomato or
vinegar) should not be permitted
to remain on the finish.
cleaningunder the
Raue
The
area under the range of models
equipped with a bottom drawer can
be reached easily for cleaning by
removing the bottom drawer. To
remove, pull drawer out all the way,
tilt up the front and remove it. To
replace, insert glides at back of
drawer beyondstop on range glides.
Lifi drawer if necessary to insert
easily. Let front of drawer down,
~henpush into close.
oven v ent
Duct
Yourrangeis ventedthrougha duct
locatedundertherightrear surface
unit. Clean the duct often.
t
"w
To remove:
~ Make sure unit is cool.
~
Lift
up right rear surfaceunit.
~
Remove
drippan andring.
@ Lifi out oven vent duct.
Toreplace:
~
Place the part over the ovenvent
located below the cooktop with
opening of the duct under the round
opening in the drip pan. It is
important that the duct is in the
correct position so moisture and
vapors from the oven can be
released during oven use. N~E:
Never cover the hole in the oven
vent duct with aluminum foil or
any other material. This prevents
the oven vent from working
properly during any cooking cycle.
Lamp Replacement
CAUT1ON: Before replacing
your oven
lamp bulb, disconnect
the electric power for your range
at the nlain fuse or circuit
brealier panel. Be
sure to let the
lamp cover and bulb cool
completely before removing or
replacing them.
The ovenlamp (bulb) is covered
with a glass r;movable coverwhich
is held in place with a bail-shaped
wire. Removeovendoor, if desired,
to reach cover easily.
To JreBnove:
~ Hold hand undercover so it
doesn'tfall when released. With
fingers of same hand, firmly push
back wire bail until it clears cover.
Lifi off cover. DO N~ REMOVE
ANY SCWWS.
@ Replace bulb with 40-watt home
appliance bulb.
To replace cover:
@ Place it into grooveof lamp
receptacle. Pull wire bail forward
to center of cover until it snaps into
place. When in place, wire holds
cover firmly. Be certain wire bail is
in depression in center of cover.
e Connect electric
power tO ra~g~.
Clean
the areaunderthe drip pans
often.Built-upsoil, especially
grease,maycatchfire. Tomake
cleaningeasier,stay-upunitslifi
up and lockin the up position,
andplug-inunitsare removable.
caution: Be sure all controls are
turned to OFF and surface Umiw
are coolbefore'
attempting t olift
orremovethem.1
Afier IiRing the stay-upunits or
removing plug-in units, remove the
trim rings and drip pans under the
units and clean them
accordingto
directionsin tl~eCleaningGuideon
page23. Wipearound theedgesof
the surface unit openings.C~ea~
the areabelowtileu~litso ~ ~ilse:Llll
washedareas witha damp clotil
or spQnge.
Advertisement
