Oven Vent Duct; Lamp Replacement - Hotpoint RB734J Use And Care Manual

CAUTION
surface units in an automatic
dishwasher.
Do not immerse plug-in surface
units in liquids of any kind.
Do not bend the plug-in surface
unit plug terminals.
in any way repair the plug-in
receptacle.

Oven Vent Duct

Your range is vented through a duct
located under the rizht rear surface
unit. Clean the duct-often.
To remove:
Make sure unit is cool.
Lift up right rear surface unit.
Remove drip pan and ring.
Lift out oven vent duct.
To replace:
located below the cooktop with
opening of the duct uncle; the round
opening in the drip pan. It is
important that the duct is in the
correct position so moisture and
vapors from the oven can be
released during oven use. NOTE:
Never cover the hole in the oven
vent duct with aluminum foil or
during any cooking cycle.

Lamp Replacement

CAUTION: Before replacing
your oven lamp bulb, disconnect
the electric power for your range
at the main fuse or circuit
breaker panel. Be sure to let the
lamp cover and bulb cool
completely before removing or
replacing them.
The oven lamp (bulb) is covered
with a ~lass removable cover which
is held;n place with a bail-shaped
wire. Remove oven door, if desired,
to reach cover easily.
To remove:
Hold hand under cover so it
doesn't fall when released. With
Lift off cover. DO NOT REMOVE
ANY SCREWS.
Replace bulb with 40-watt home
appliance bulb.
To replace cover:
Place it into groove of lamp
receptacle. Pull wire bail forward
to c~nter of cover until it snaps into
place. When in place, wire holds
cover firmly. Be certain wire bail is
in depression in center of cover.
Connect electric power to range.
25
Oven Lamp—
Non-Self-Cleaning Upper
Oven On HI/LOW Range
(Model RH758)
To remove:
Disconnect electric power to
range at main fuse or circuit
breaker panel.
. Hold glass cover and remove
screw. Pull glass cover forward,
then down and remove.
Replace lamp with 40-watt
appliance lamp.
: ,,-
-
-0
.)
-
To replace:
Tuck extension on glass cover
into back of lamp opening.
Fit cover over opening and
replace washer and screw. (When
removing and replacing cover, if
thermostat tube should be moved
out of place, be certain it is returned
to its proper horizontal position,
and about 1/2 inch from cover. )
Connect electric power to range.
Cooktop Surface Lamp
WHEN CHANGING A
COOKTOP LAMP, DO NOT
TOUCH THE METAL AT ENDS
OF LAMR
1. Hold glass panel assembly and
remove the three screws from metal
frame which holds top of assembly
in place.
2. Hold assembly in both hands,
lower it until it is removed.
3. Remove lamp(s) and replace
with bulb of the same wattage. Lift
glass panel assembly into place and
replace screws in top of assembly
to hold it in place.
4. Connect electric power to range.