Introduction; Document Conventions - Motorola AP-6562 Installation Manual

Hide thumbs Also See for AP-6562:
Table of Contents

Advertisement

Installation Guide

1 Introduction

The AP-6562 access point links wireless 802.11abgn devices, enabling the growth of your wireless network with a
cost effective alternative to standard access points. The AP-6562 access point provides multiple deployment
options.
The AP-6562 access point receives all power and transfers data through the same CAT-5 or better Ethernet cable.
An 802.3at Ethernet switch or power supply (specifically rated for the AP-6562) is required, such as the
AP-PSBIAS-7161-US or AP-PSBIAS-7161-WW outdoor rated power supply
An AP-6562 model access point uses WiNG 5 software as its onboard operating system. The access point's unique
WiNG 5 software enables the access point to function as either a Virtual Controller AP capable of adopting and
managing up to 24 additional AP-6562 access points or a Standalone access point managed by its connected
controller.
If new to access point technology, refer to the WiNG Access Point System Reference Guide to familiarize yourself
with access point technology and the feature set supported by the WiNG operating system. The guide is available
at
www.zebra.com/support.
The AP-6562 access point is approved under MODEL: AP-6562.
This document is written for the qualified network device installer.

1.1 Document Conventions

The following graphical alerts are used in this document to indicate notable situations:
NOTE
CAUTION
WARNING!
Tips, hints, or special requirements that you should take note of.
Care is required. Disregarding a caution can result in data loss or
equipment malfunction.
Indicates a condition or procedure that could result in personal injury or
equipment damage.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents