Introduction; Document Conventions; Warnings - Motorola AP6532 Series Installation Manual

1

Introduction

The AP6532 Access Point, a component of the Motorola Solutions Wireless Controller System, links
wireless 802.11a/b/g/n devices to the controller, enabling growth of your wireless network with a
costeffective alternative to standard Access Points. The AP6532 Access Point provides two
placement options: wall and ceiling. Wall mount slots fit onto two provided screws. Arrows on the
case guide the placement of the screws. For placement above a suspended ceiling, a safety wire tie
point on the case provides for a safety wire loop. The light pipe fits through a hole in the ceiling tile
to provide a view of the unit's status lights.
The AP6532 Access Point receives all power and transfers data through the same CAT-5 or better
Ethernet cable. There is no additional power supply required. An 802.3af Ethernet switch or power
injector is required.

1.1 Document Conventions

The following graphical alerts are used in this document to indicate notable situations:
NOTE
CAUTION
WARNING!

1.2 Warnings

• Read all installation instructions and site survey reports, and verify correct equipment
installation before connecting the AP6532 Access Point.
• Remove jewelry and watches before installing this equipment.
• Verify that the unit is grounded before connecting it to the power source.
• Verify that any device connected to this unit is properly wired and grounded.
Tips, hints, or special requirements that you should take note of.
Care is required. Disregarding a caution can result in data loss or
equipment malfunction.
Indicates a condition or procedure that could result in personal injury or
equipment damage.
1
Introduction