Table of Contents
Advertisement
Installation Guide
1 Introduction
The AP6562E Access Point, a component of the Motorola Solutions wireless controller system, links wireless
802.11abgn devices, enabling the growth of your wireless network with a cost effective alternative to standard
Access Points. The AP6562E Access Point provides multiple deployment options.
The AP6562E Access Point receives all power and transfers data through the same CAT-5 or better Ethernet cable.
An 802.3at Ethernet switch or power supply (specifically rated for the AP6562E) is required. Motorola Solutions
recommends the AP-PSBIAS-7161-US or AP-PSBIAS-7161-WW outdoor rated power supply
An AP6562E model Access Point uses WiNG 5 software as its onboard operating system. The Access Point's
unique WiNG 5 software enables the Access Point to function as either a Virtual Controller AP capable of
adopting and managing up to 24 additional AP6562E Access Points or a Standalone Access Point managed by its
connected controller.
If new to Motorola Solutions Access Point technology, refer to the WiNG Access Point System Reference Guide to
familiarize yourself with Access Point technology and the feature set supported by the WiNG operating system.
The guide is available at https://portal.motorolasolutions.com/Support/US-EN/Wireless+Networks.
The AP6562E Access Point is approved under MODEL: AP-6562E.
This document is written for the qualified network device installer.
1.1 Document Conventions
The following graphical alerts are used in this document to indicate notable situations:
NOTE
CAUTION
WARNING!
Tips, hints, or special requirements that you should take note of.
Care is required. Disregarding a caution can result in data loss or
equipment malfunction.
Indicates a condition or procedure that could result in personal injury or
equipment damage.
5
Advertisement
Table of Contents
