Motorola AP-6562 Installation Manual page 26

26
• Standalone AP - Select this option to deploy this Access Point as an autonomous fat Access Point.
A Standalone AP isn't managed by a Virtual Controller AP, or adopted by a controller
NOTE
NOTE
11. Select the Country Code of the country where the Access Point is deployed. Selecting a proper country
is a critical task while configuring the Access Point, as it defines the correct channels of operation and
ensures compliance to the regulations of the selected country. This field is only available for the Typical
Setup Wizard.
12. Select Next to set the Access Point's network mode.
If wanting to adopt the Access Point to a controller or service platform,
use the controller or service platform's resident UI to connect to the
Access Point, provision its configuration and administrate the Access
Point's configuration.
If designating the Access Point as a Standalone AP, use the Access
Point's UI to define its device configuration, and not the CLI. The CLI
provides the ability to define more than one profile and the UI does not.
Consequently, the two interfaces cannot be used collectively to manage
profiles without an administrator encountering problems.
AP-6562 Access Point
.