Vmm Mounting And Installation - Motorola AP-7562 Installation Manual

18

1.11 VMM Mounting and Installation

The AP-7562 Vehicle Mounted Modem (VMM) is a software enabled profile within the WiNG 5 architecture that
uses the same hardware as the AP-7562 Access Point infrastructure models.
An AP-7562 Access Point operating as a VMM can be permanently mounted in a vehicle. It provides mesh backhaul
access to a mesh infrastructure network to connect mobile data terminals, laptop computers, or any other device
with either Ethernet or 802.11 wireless capability. The VMM operates on Power over Ethernet (PoE) and is rugged
enough for installation in commercial and public safety vehicles for mobile deployments. Zebra recommends using
the vehicle mount kit (KT-158767-01) for mobile deployments.
To install the Access Point VMM:
1. Remove rubber plugs from four screw holes on the LED side of the AP-7562. Position unit with screw holes
facing upwards.
2. Put the flat plate on top of the VMM. Align the key hole and four screw holes on the flat plate with the
philips screw head and four screw holes on the VMM.
3. Put the chassis mount on the flat plate with the key hole and four screw holes aligned.
NOTE
The screw heads on the chassis mount should be facing down.
AP-7562 Access Point