Installation Guide
3. Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, attach the extension arm
to the Access Point bracket with four M6 hex flange screws. The two oval holes must be positioned on
the short sides of the Access Point. Tighten the hex flange screws to 60 inch pounds (lbf-in) the unit.
4. With the Access Point positioned so the gore vent is facing down, attach the extension arm to the Access
Point bracket with two 1/2 inch bolts and nuts. Tighten the nuts to 300 inch pounds (lbf-in).
31