Checking The Free Travel Of The Foot Brake Lever; Adjusting The Free Travel Of The Foot Brake Lever; Adjusting The Basic Position Of The Foot Brake Lever - KTM 65 SX Owner's Manual

12 BRAKE SYSTEM
12.10

Checking the free travel of the foot brake lever

Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to
overheating. Adjust the free travel on foot brake lever according to specifications.
12.11

Adjusting the free travel of the foot brake lever

Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to
overheating. Adjust the free travel on foot brake lever according to specifications.
12.12

Adjusting the basic position of the foot brake lever

Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to
overheating. Adjust the free travel on foot brake lever according to specifications.
–
Disconnect spring
–
Move the foot brake lever back and forth between the end stop and the foot brake
cylinder piston bracket and check free travel
Guideline
Free travel of foot brake lever
» If the free travel does not meet specifications:
–
Adjust the free travel of the foot brake lever.
–
Attach spring
H00160-10
–
Detach the spring.
–
Loosen nut
–
Turn push rod
Guideline
Free travel of foot brake lever
–
Hold push rod
–
Attach the spring.
–
Check whether the basic position of the foot brake lever is suitable for the rider.
H00161-10
» When the basic position of the foot brake lever needs to be adjusted:
–
Adjust the basic position of the foot brake lever.
–
Detach the spring.
–
Loosen nut
–
Turn back push rod
–
Loosen nut
–
To adjust the basic position of the foot brake lever, turn screw
Info
The range of adjustment is limited.
H00161-11
–
Hold screw
Guideline
Remaining nuts, chassis

.

.

.
 
until clearance is created.
 
and tighten nut .
 .

.

.
 
and tighten nut .
 .
3... 5 mm (0.12... 0.2 in)
( p. 53)
3... 5 mm (0.12... 0.2 in)
( p. 53)

accordingly.
M8 25 Nm
(18.4 lbf ft)
53