KTM 65 SX Owner's Manual page 46

11 SERVICE WORK ON THE CHASSIS
–
Check the chain sliding guard for wear.
» If the lower edge of the chain pin is at the level of or below the chain sliding
guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the chain sliding guard.
B00382-01
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the chain sliding piece.
Guideline
Remaining screws, chassis
B00383-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the chain guide.
Guideline
Remaining screws, chassis
H00131-01
Finishing work
–
Remove the motorcycle from the lift stand. (
M8 25 Nm
(18.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
p. 28)
44