Changing The Hydraulic Clutch Fluid - KTM 65 SX Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.43

Changing the hydraulic clutch fluid

Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
The fluid level rises with increasing wear of the clutch facing discs.
Info
Clean up overflowed or spilled brake fluid immediately with water.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
H00132-11
–
Fill bleeding syringe
Bleed syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the slave cylinder, remove the bleeder screw and mount bleeding syringe
H00109-10
–
Inject the liquid into the system until it escapes from drill hole
cylinder without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten screws bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
H00108-10

.
 
with membrane .
 with the appropriate hydraulic fluid.
p. 81)

of the master
4 mm (0.16 in)
47

.