Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.19
Adjusting the basic position of the clutch lever
Info
Turn the adjusting screw clockwise to increase the distance between the clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding.
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws, chassis
601884-01
Finishing work
–
Remove the rear of the motorcycle from the wheel stand. (
M6
10 Nm
(7.4 lbf ft)
p. 71)
86
Advertisement
Table of Contents
