Floor Protection Requirements; Stove Placement Requirements; Clearances - Lopi Evergreen Owner's Manual

8 Stove Installation

Floor Protection Requirements

Floor protection must extend to the sides, rear, and front of the stove (see "Clearances" below for
minimum floor protection).
Floor protection must be non-combustible and have a thermal resistance equal to 9mm Bellis Board.

Stove Placement Requirements

Clearances may be reduced by methods specified in NFPA 211, listed wall shields, pipe shields, or
other means approved by local building or fire officials.
Stove must be placed so that no combustibles are within, or can swing within 914mm (36") of the
front of the stove (drapes, doors, etc.)
Must maintain the clearances to combustibles listed below (drywall, furniture)
The stove requires an air source to operate. Combustion air starvation will result in poor performance
or smoke in the house.

Clearances

The following clearances must be met
M i i n m u m C
A S d i e
B Back wall to stove
C Corner wall to stove
D F o r
E S d i e
F B a k c
AUSTRALIAN FLUE KIT REQUIREMENTS:
The above clearances are in accordance to the following:
The heater is to be installed with a 150mm/6" Stainless Steel triple skin (default) flue kit (fitted with heat
shields see below) which conforms to the requirements of the joint AS/NZS 2918:2001 Standard,
Appendix, with respect to the rear wall, side wall, floor and ceiling surface temperatures, when tested in
the positions shown.
Heat Shield Options:
1. 200mm/8" Decorative Mesh, up into the drop box, with the 1
2. Stainless Steel ½ Heat Shield 900mm minimum length x 180 degrees.
. 3 2 0 0 m m v e t n a l i e t d
© T a r v s i n I d u s r t e i s
e l a a r n c e
w l l a o t s o t v e
t n h e r a h t
h e r a h t
h e r a h t
f , u l e p p i e u p n i o t h t e d
(for qualified installers only)
W i h t F u l e
3 2 5 m m
200 mm
100 mm
3 0 0 m m
2 0 0 m m
2 0 0 m m
length (900mm) to have a solid back.
st
o r p b o . x
1 0 0 0 - 1 4 3 8
S h e i d l
4 1 6 0 3 0 3