Door Parts; Replacing The Glass; Replacing The Door Gasket; Replacing The Door Handle - Lopi Evergreen Owner's Manual

Door Parts

3
1
2
ID # Description
1 RTV High Temp. 600° Silicone
2 Door Gasket
3 Screws (8) 10-24 x ½"
4 Door Retainer

Replacing the Glass

The glass must not contact the door retainer or glass clips directly. The glass gasket and glass clip
gaskets insulate the glass to prevent cracking. Do not over-tighten the glass clips. Do not use substitute
materials.

Replacing the Door Gasket

The door gasket inserts into the outer groove of the door, and is held in place with RTV high-temperature
silicone. Before installing, remove any residual cement. Lay the gasket in place (start at the lower right
corner) and cut off any excess gasket.
NOTE: Do not stretch the gasket. You may need to open and close the door repeatedly to get the gasket
to seat fully.

Replacing the Door Handle

See the illustration above for a component list (see page 27 for details on adjusting the door).

Removing the Door

To remove the door, open the door, then remove the four hex screws securing the hinges and remove the
door and hinges as one assembly (see page 27 for details on removing the door).
NOTE: It will be helpful to have another person hold the door in place while removing the screws.
© Travis Industries
Maintaining Your Appliance
6
5
4
Qty. Part #
99900427
1 250-02832
1 250-03656
1 250-03657
100-01438
ID # Description
5 Glass
6 Glass Gasket
7 Door Handle Assy.
8 Door Handle
29
7
8
Qty. Part #
1 250-03605
1 99900405
1 250-03606
1 250-01305
4160303