Table of Contents
Advertisement
Facing Overview
Upgrade faces are available for this fireplace and may influence facing installation. Consult with your
Travis Dealer if you are using an upgrade face.
Optional non-combustible facing may be installed on the fireplace. Use the guidelines below to determine the
location (also see the following pages for detailed diagrams.
Any non-combustible facing under 1" (25mm) thick (see "Thin Facing" on page 32).
Tile Line
Any non-combustible over 1" (25mm) thick (see "Thick Facing" on page 34).
Masonry Line
Non-combustible hearth/facing should be installed up to this location (1" (25mm) above the base of the
Hearth Line
fireplace). The fireplace may be raised to accommodate thicker hearth materials.
Optional Faceplates – Sizing Chart
Name
FPX Artisan, Classic, Fr Ctry
Winthrop Victorian Lace
Wilmington Hearthview
Winthrop Bungalow
© Travis Industries
Installation
(for qualified installers only)
NOTE: The hearth or facing can extend no
greater than 1" (25mm) above the base of the
fireplace. The fireplace may be raised to
accommodate thicker hearth materials.
Height
Width
35-3/4"
41"
(908mm)
(1041mm)
34-1/8"
36-7/8"
(867mm)
(937mm)
35-3/4"
41"
(908mm)
(1041mm)
34"
36-7/8"
(864mm)
(937mm)
4090507
SPECIAL INSTRUCTIONS FOR
WILMINGTON FACES
Remove the center deflector (use needle-
nose pliers if necessary).
These tabs bend down
to allow for removal.
Re-attach the deflector to the louver.
Bend the tabs as shown, making sure
the deflector is secure and flat.
WARNING: The deflector must be
replaced in its original position if a
different face or grill is used.
Notes
45-3/4" (1162mm) Radius – May fit over top of tile
facing
Optional facing will butte to edge of faceplate (tile
line)
May fit over top of tile facing
Optional facing will butte to edge of faceplate (tile
line)
31
100-01217_000
Advertisement
Table of Contents
