Table of Contents
Advertisement
66
Optional Equipment
10
The stepper motor (adjustable regulator) has an installation sheet included with it – make sure to
follow all of the directions. Place the stepper motor on the gas control valve (see Figure 14) –
MAKE SURE IT IS CORRECTLY ORIENTED. Secure using the screws included with the motor
(see Figure 15) – tighten to 25 Lb-inches. Leak test this area after installation to verify proper
installation.
11
Place the GreenSmart wiring harness in front of the fireplace, noting the position of each
connector (see .Figure 16).
12
Attach the wiring harness to the burner control (see Figure 17). Attach the gas control valve
molex connector (see Figure 18).
© Travis Industries
(for qualified installers only)
Figure 14
Figure 17
4090507
Figure 15
Figure 16
Figure 18
100-01217_000
Advertisement
Table of Contents
