Call Park - Yealink SIP-T22P User Manual

User Guide SIP-T22P IP Phone
The active call is placed on hold.
3. Enter the number of the second party and press
4. When the second party answers the call, press the Conf soft key to add the second
party to the conference.
5. Press the Conf soft key to create a new call.
The conference is placed on hold.
6. Enter the number of the new party and then press
7. When the new party answers the call, press the Conf soft key to add the new party
to the conference.
8. Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call for specific servers may be different
from introduced above. Contact your system administrator for more information.
You can use call park feature to place a call on hold, and then retrieve the call from
another phone in the system (for example, a phone in another office or conference
room). You can park an active call by pressing the call park key on the phone. If the call
is parked successfully, the response is either a voice prompt confirming that the call was
parked, or a visible indication on the LCD screen.
Note
Call Park feature is not available on all servers. Contact your system administrator for
more information.
To configure a call park key via phone user interface:
1. Press Menu->Features->DSS Keys.
2. Select the desired DSS key.
3. Press
4. Press
5. Press
ID field.
6. Enter the call park feature code (contact your system administrator for it) in the
Value field.
76
or , or the Switch soft key to select Key Event from the Type field.
or , or the Switch soft key to select Call Park from the Key Type field.
or , or the Switch soft key to select the desired line from the Account
, , or the Send soft key.
, , or the Send soft key.