Device Streaming Registers; Start - End Command Requirements; File Access Control Category; File Access Control Feature Descriptions - Teledyne Linea 2K CL User Manual

Device Streaming Registers

Start – End Command Requirements
Important: Every start command must have a corresponding end command. If not the
camera can be in an unpredictable state. This pertains to
DeviceRegistersStreamingStart, DeviceRegistersStreamingEnd,
DeviceFeaturePersistenceStart, and DeviceFeaturePersistenceEnd.
Display Name
Device Registers
Streaming Start
Device Registers
Streaming End
Device Feature
Streaming Start
Device Feature
Streaming End
Register Check
Registers Valid

File Access Control Category

The File Access control in CamExpert allows the user to quickly upload various data files to the
connected Linea CL. The supported data files are for Linea CL firmware updates and Flat Field
coefficients.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications.

File Access Control Feature Descriptions

Display Name
File Selector
FPGA Code
Micro Code
66 • Appendix A: GenICam Commands
Feature & Values
DeviceRegistersStreamingStart
DeviceRegistersStreamingEnd
DeviceFeaturePersistenceStart
DeviceFeaturePersistenceEnd
DeviceRegistersCheck
DeviceRegistersValid
Feature & Values
FileSelector
FPGA Code
Micro Code
CCI
XML
Description
Announces the start of registers streaming without
immediate checking for consistency.
Announces end of registers streaming and performs
validation for registers consistency before activating
them.
Announces the start of feature streaming without
immediate checking for consistency.
Announces end of feature streaming and performs
validation for feature consistency before activating
them.
Performs an explicit register set validation for
consistency.
States if the current register set is valid and
consistent.
Description
Selects the file to access. The file types which
are accessible are device-dependent.
Upload new FPGA to the camera which will
execute on the next camera reboot cycle.
Upload new micro codeto the camera which will
execute on the next camera reboot cycle.
CCI Upload new CCI to the camera which will
execute on the next camera reboot cycle.
XML Upload new XML to the camera which will
execute on the next camera reboot cycle.
Standard
& View
Invisible
Invisible
Invisible
Invisible
Invisible
Invisible
Standard
& View
Guru
Linea CL Series Camera