Transport Layer Category; Transport Layer Descriptions - Teledyne Linea 2K CL User Manual

Transport Layer Category

The Linea CL Transport Layer, as shown by CamExpert, groups features for Camera Link
configuration. Parameters in gray are read only, either always or due to another parameter being
disabled. Parameters in black are user set in CamExpert or programmable via an imaging
application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications.

Transport Layer Descriptions

The following table describes these features along with their view attribute. Additionally the
Standard & View column will indicate which parameter is a member of the DALSA Features Naming
Convention (indicated by DFNC), versus the GenICam Standard Features Naming Convention
(SFNC not shown).
Display Name Feature & Values
Restart Camera DeviceReset
XML Major Version DeviceManifestXMLMajorVersion
XML Minor Version DeviceManifestXMLMinorVersion
Last GenCP Status genCPStatus
Refresh GenCP Status refreshGenCPStatus
Camera Link ClConfiguration
Configuration
Base
Medium
Full
Deca
Camera Link Speed clDeviceClockFrequency
77MHZ
50MHZ
85MHZ
62MHZ
Tap Geometry DeviceTapGeometry
Linea CL Series Camera
Description
Used to restart the camera, warm reset
Together with DeviceManifestXMLMinorVersion
specifies the GenICam™ feature description XML
file version (RO)
Together with DeviceManifestXMLMajorVersion
specifies the GenICam™ feature description XML
file version (RO)
If a feature read or write fails then Sapera only
returns that it fails – read this feature to get the
actual reason for the failure
Returns the last error
Reading this feature clears it
Updates the genCPStatus value.
Camera Link Output configuration.
Base Camera Link Base configuration.
Medium Camera Link Medium configuration.
Full Camera Link Full configuration.
Deca Camera Link Deca configuration.
Set the camera link clock rate
Speed_77MHZ 2K, 4K and 8K models only.
Speed_50MHZ 2K, 4K and 8K models only.
Speed_85MHZ 16K model only.
Speed_62MHZ 16K model only.
(RO)
Appendix A: GenICam Commands • 65
Standard
& View
Beginner
Invisible
Invisible
DFNC
Invisible
DFNC
Beginner
Beginner
Beginner
Beginner