Camera Control Category; Camera Control Feature Descriptions - Teledyne Linea 2K CL User Manual

Camera Control Category

The Linea CL camera controls, as shown by CamExpert, groups sensor specific features. This group
includes controls for line rate, exposure time, and so forth. Parameters in gray are read only, either
always or due to another feature being disabled. Parameters in black are user set in CamExpert or
programmable via an imaging application.
Features listed in the description table but tagged as Invisible are usually for Teledyne DALSA or
third party software usage—not typically needed by end user applications.

Camera Control Feature Descriptions

The following table describes these features along with their view attribute. Additionally the
Standard & View column will indicate which feature is a member of the custom DALSA Features
Naming Convention (indicated by DFNC), versus the GenICam Standard Features Naming
Convention (SFNC not shown).
Display Name
Sensor Color Type
Monochrome
Internal Line Rate
Measured Line Rate
Measured CC1
Refresh measured line rate
Exposure Time Source
Timed
Trigger Width
Exposure Time
Measured Exposure Time
Refresh Measured Exposure
Time
Offset
Gain
60 • Appendix A: GenICam Commands
Feature & Values
sensorColorType
Monochrome
AcquisitionLineRate
measureLineRate
measureCC1Rate
refreshMeasureLineRate
ExposureMode
Timed
TriggerWidth
ExposureTime
measureExposureTime
refreshMeasuredExposureTime
BlackLevel
Gain
Description
Defines the camera sensor color type. < RO >
Sensor color type is monochrome.
Specifies the camera internal line rate, in Hz.
Displays the line rate provided to the camera by
either internal or external source < RO >
Displays the CC1 signal rate provided to the
camera. < RO >
Updates the measureLineRate value.
Sets the operation mode for the camera's
exposure.
The exposure duration time is set using the
Exposure Time feature and the exposure starts
with a LineStart event.
Uses the width of the trigger signal pulse to control
the exposure duration. Use the Trigger Activation
feature to set the polarity of the trigger. The
Trigger Width setting is applicable when the
LineStart trigger is enabled and a signal is selected
as trigger source.
Sets the exposure time (in microseconds) when the
Exposure Mode feature is set to Timed.
Displays the exposure time used by the camera
sensor.
Updates the measuredExposureTime value.
Analog black level (offset) in DN. Controls the black
level as an absolute physical value. This represents
a DC offset applied to the video signal.
Sets the gain as an amplification factor applied to
the image.
Standard
& View
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
DFNC
Beginner
Beginner
Beginner
DFNC
Beginner
DFNC
Beginner
Beginner
Beginner
Linea CL Series Camera