Flash Code 13 (Sid 146/Fmi 6) Egr Valve Current Too High; Flash Code 16 (Sid 146/Fmi5) Egr Valve Current Too Low - Detroit Diesel Series 60 EGR Technician Manual

DDEC V TESTING
TROUBLESHOOTING TASKS
The following ordered tasks are recommendations to troubleshoot specific operational concerns.

FLASH CODE 13 (SID 146/FMI 6) EGR VALVE CURRENT TOO HIGH

Troubleshooting steps are as follows.
1. Using DDDL, check for Flash Code 13 (SID 146/FMI 6).
[a] If Flash Code 13 (SID 146/FMI 6) was logged, perform TEST E.
[b] If Flash Code 13 (SID 111/FMI 4 or 6) was logged, refer to the proper code section of
the DDEC V Single ECU Troubleshooting Guide, (6SE565) to troubleshoot that code.
2. Once troubleshooting is done, verify that troubleshooting step 1[a] or step 1[b] resolved
the problem.
[a] If Flash Code 13 (SID 146/FMI 6) is still logged, contact the Detroit Diesel Customer
Support Center at 313-592-5800.
[b] If Flash Code 13 (SID 146/FMI 6) is not logged, troubleshooting task is complete.

FLASH CODE 16 (SID 146/FMI5) EGR VALVE CURRENT TOO LOW

Troubleshooting steps are as follows.
1. Using DDDL, check for Flash Code 16 (SID 146/FMI 5).
[a] If Flash Code 16 (SID 146/FMI 5) was logged, perform TEST E.
[b] If Flash Code 16 (SID 111/FMI 5) was logged, refer to the proper code section of the
DDEC V Single ECU Troubleshooting Guide, (6SE565) to troubleshoot that code.
2. Once troubleshooting is done, verify that troubleshooting step 1[a] or step 1[b] resolved
the problem.
[a] If Flash Code 16 (SID 146/FMI 5) is still logged, contact the Detroit Diesel Customer
Support Center at 313-592-5800.
[b] If Flash Code 16 (SID 146/FMI 5) is not logged, troubleshooting task is complete.
10-2
All information subject to change without notice. (Rev. June 2005)
7SE60 0506 Copyright © 2005 DETROIT DIESEL CORPORATION