Print Area - Canon imagePROGRAF iPF680 User Manual

Hide thumbs Also See for imagePROGRAF iPF680:
Table of Contents

Advertisement

iPF680
Interface
USB
Ethernet
Ink
For information on the ink the printer supports, see "Ink Tanks."
Paper
For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See "Displaying
the Paper Reference Guide.")
Paper width
Minimum paper length
Maximum printable length ( *1 )
Thickness
Roll maximum outer diameter
Supported paper core inner diameter

Print area

*1: Varies depending on the operating system or application.
Roll Holder Set
Stand
Stand( *1 )
*1: The stand that is included depends on the region where you purchased the printer.
Print Area
Print Area
A margin required by the printer is added with respect to the size of paper loaded in the printer. Except in border-
less printing, the actual printing area corresponds to the paper size minus the space for this margin.
Printable Area: The area that can be printed.
There is no margin (that is, a margin of 0 mm) during borderless printing on rolls.
Note
Recommended Print Area: We recommend printing within this area.
To print so that your original matches the print area exactly, use an oversized paper size that includes the required
margin. (See "Printing on Oversize Paper.")
Top Edge
Sheets
3 mm (0.12 in)
Rolls
0/3 mm (0/0.12 in)
User's Guide
Format
Mode
Connector
Format
Specification
Protocols
P.329
For information on the paper widths the printer supports, see "Paper Sizes."
Rolls
Sheets
Rolls
Sheets
Rolls
Sheets
For details, see "Print Area."
Margins of Printable Area
Bottom Edge
23 mm (0.91 in)
3 mm (0.12 in)
0/3 mm (0/0.12 in)
0/3 mm (0/0.12 in)
Internal port
Full-speed (12 Mbps), high-speed (480 Mbps), bulk transfer
Series B (4-pin)
Internal port
IEEE 802.3 10Base-T,
IEEE 802.3u 100Base-TX/Auto-Negotiation,
IEEE 802.3ab 1000Base-T/Auto-Negotiation,
IEEE 802.3x Full Duplex
IEEE 802.3az EEE
SNMP (supports Canon-MIB), HTTP, TCP/IP (IPv4/IPv6)
P.496
203.2 mm (8.0 in)
279.4 mm (11.0 in)
18 m (19.7 yd)
1,600 mm (63.0 in)
0.07–0.8 mm (0.0028–0.031 in)
0.07–0.8 mm (0.0028–0.031 in)
150 mm (6 in) or shorter
2 inches / 3 inches
P.579
Roll Holder Set RH2-26
Printer Stand ST-27
Printer Stand ST-27
P.70
Margins of Recommended Print Area
Sides
Top Edge
20 mm (0.79 in)
20 mm (0.79 in)
P.326
Bottom Edge
Sides
23 mm (0.91 in)
5 mm (0.20 in)
5 mm (0.20 in)
5 mm (0.20 in)
Print Area
579

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents