Canon imagePROGRAF iPF680 User Manual page 342

Changing the Type of Paper
•
For best printing results, the printer fine-tunes the print head height and the feed amount for each type of paper.
Be sure to select the type of paper to use correctly before printing.
Important
•
Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printed im-
ages may vary depending on the type of paper used. If margins and the size of images are not as you expected,
adjust the paper feed amount.
(See "Adjusting the Feed Amount.")
•
Rolls and sheets have different printing areas, and sheets having a larger bottom margin than rolls.
(See "Print Area.")
Changing the Type of Paper
•
When you load a roll, a menu for selection of the type of paper is shown on the Display Screen. Select the type of
paper, and then press the OK button.
Note
If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the roll length after
the type of paper. (See "Specifying the Paper Length.")
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Paper tab (
Note
2
Press the OK button.
The Paper Menu is displayed.
3
Press ▲ or ▼ to select Chg. Paper Type, and then press the OK button.
4
Press ▲ or ▼ to select the type of paper loaded ( Roll Paper or Cut Sheet ), and then press the OK
button.
5
Press ▲ or ▼ to select the type of paper loaded in the printer, and then press the OK button.
Important
Note
Using the Same Type of Paper Regularly
Configure this setting so that current media type settings will be automatically selected when you load the same
type of paper later.
1
342
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Paper tab (
P.579
➔
).
•
If the Tab Selection screen is not displayed, press the Menu button.
•
Be sure to select the correct paper type. If this setting does not match the loaded paper, it may cause
feed errors and affect printing quality.
•
For details on types of paper, see the Paper Reference Guide. (See "Types of Paper.")
fault, Plain Paper is selected.
•
If you move the Release Lever, the setting automatically reverts to the previously selected paper.
).
P.487
➔
P.343
➔
iPF680
By de-
P.326
➔
User's Guide