Canon imagePROGRAF iPF680 User Manual page 423

iPF680
Inter- TCP/IP IPv6
face
Setup
Ether- Auto Detect
net
Driver
Comm.Mode
Ethernet Type
Spanning Tree
MAC Address
Interface Print
Return Defaults
System Sleep Timer
Setup
Shut Down Timer
Buzzer
Contrast Adj.
Date & Date
Time
Time
Date Format
Language
Time Zone
Length Unit
Detect Mismatch
Paper Roll Selection 1
Size Ba-
sis
Roll Selection 2
Keep Paper Size
User's Guide
Setting Item
DNS
Sec. DNS SrvAddr
Settings
DNS Host Name
DNS Domain Name
Description, Instructions
Specify the DNS server address.
Specify the DNS host name.
Specify the DNS domain name.
Specify the communication method. To apply your
changes, choose Register Setting.
Choose On for automatic configuration of the LAN com-
munication protocol. Choose Off to use settings values of
Comm.Mode and Ethernet Type.
Choose the LAN communication method.
Choose the LAN transfer rate.
Choose whether spanning-tree packets are supported
over the LAN.
Indicates the MAC address.
Print interface settings information.
Choose OK to restore Interface Setup settings to the de-
fault values.
Specify the period before the printer enters sleep mode.
Sets the time until the printer turns off automatically. If no
operations are performed on the printer for the duration of
the time set in Shut Down Timer after entering Sleep
mode, the printer automatically turns off.
Choose On for the buzzer to sound once for warnings and
three times for errors.
Adjust the Display Screen contrast level.
Set the current date.
Set the current time. Available only if the Date setting is
specified.
Specify the date format.
Specify the language used on the Display Screen.
Specify the time zone. Time zone options indicate a main
city in this time zone and the difference from Greenwich
Mean Time.
Choose the display unit for length. Change the unit dis-
played for the remaining amount of roll paper, Tot.Print
Area, and so on.
Specify printing behavior if the type and size of paper
specified in the printer menu does not match the type and
size in the printer driver.
Choose Pause to have printing paused under these cir-
cumstances. Choose Warning to continue printing after
notification. Choose None to continue printing without no-
tification.
If roll size detection is activated, choose whether ISO A3
(297mm) or 300mm Roll is applied when a roll of an in-
termediate width is detected.
If roll size detection is activated, choose whether 10in.
(254mm) or JIS B4 (257mm) is applied when a roll of an
intermediate width is detected.
Choose On to use the paper size setting as the basis for
printing instead of other settings. The margin setting of the
printer menu will be used instead of the margin setting of
the printer driver if the latter is smaller, which may prevent
text or images in the margin from being printed.
Menu Settings
423