Table of Contents
Advertisement
Table 6-4
KEY
ON/OFF Switch
START
STOP
INLET
SELECT
PRIME
TEMP
RPM
TIME
TOTAL VOLUME MODE
DISPLAY
SHOWS
xxx mL
or
NOTE: if you turn off the pump motor's power, the pump stops
xxx Liters
To continue pumping, turn on the unit's power. The display
returns to the STOPPED Display Mode and shows the volume of
fluid dispensed during pumping. Then press the START/STOP
key.
xxx mL
or
To resume pumping for the remainder of the TOTAL VOLUME
xxx Liters
setting, press the START/STOP key. The display enters the
RUNNING Display Mode, and the fluid begins to dispense.
Must STOP first!
To select the other inlet and reverse the direction of pumping:
1.
2.
3.
4.
STOP to Prime...
To prime a tube:
1.
2.
3.
4.
xxx °C
NOTE: The TEMP key functions the same whether the pump is
xxx rpm
Press the RPM key. The display flashes the actual pump motor
speed (xxx rpm).
xx:xx:xx
Press the TIME key. The display flashes the time that the pump
has been running (xx:xx:xx:).
ACTION TAKEN
AND PROCEDURE
Pump motor's power
running.
Pump(s) stops; press again pump(s) starts
LEDs indicate new pump direction
Press the START/STOP key. The display returns to the
STOPPED Display Mode.
Press the INLET SELECT key to reverse the direction of
pumping.
Press the START/STOP key again to resume pumping.
For detailed instructions on "Defining the Direction of
Pumping, refer to Section 5.2.
Pumps fluid at current rpm or flow rate
setting as long as the key is pressed
Press the START/STOP key to stop the pump. The display
returns to the STOPPED Display Mode.
Press and hold down the PRIME key to prime the tube.
Press the START/STOP key again to resume pumping.
For detailed instructions on "Priming a Tube", refer to Section
5.4.
Display alternates when pressed, °C then °F.
stopped or running. Refer to Section 5.6.
Displays actual RPM
Displays cumulative TIME since start
6-19
Advertisement
Table of Contents
