Selecting The Tubing Inner Diameter - Omega Engineering OMEGAFLEX FPU5-MT-110 User Manual

5
Operating the Pump Motor in the STOPPED Display Mode
3.
4.

5.3 Selecting the Tubing Inner Diameter

The TUBE ID, and UP and DOWN ARROW keys allow you to select the inner
diameter of the tubing.
5-4
INLET SELECT
LEFT PUMP
INLET
SELECT
TEMP
MOTOR TURNING
COUNTER-CLOCKWISE
Left Pump
INLET SELECT
LEFT PUMP
INLET
SELECT
TEMP
MOTOR TURNING
Left Pump
Figure 5-1. Defining the Direction of Pumping
To change the direction of pumping, press the INLET SELECT key. The lit, green
LEDs change positions. Fluid flows in the opposite direction.
To change back to the original direction of pumping, simply press the INLET
SELECT key again.
With the peristaltic pump motor, you can either select a tubing size from
those shown in the display (using the TUBE ID key), or you can calibrate
each piece of tubing you use (using the CALIBRATE key, as described in
Section 5.5).
TIME
RPM
FLOW
TOTAL
RATE VOLUME
TUBE ID
CALIBRATE
MOTOR TURNING
CLOCKWISE
INLET
OUTLET
TIME
RPM
FLOW TOTAL
RATE VOLUME
TUBE ID CALIBRATE
MOTOR TURNING
CLOCKWISE COUNTER-CLOCKWISE
OUTLET
INLET
NOTE
INLET SELECT
RIGHT PUMP
PRIME
START
STOP
OUTLET
INLET
Right Pump
INLET SELECT
RIGHT PUMP
PRIME
START
STOP
INLET
OUTLET
Right Pump