Table of Contents
Advertisement
Table 6-2
KEY
ON/OFF Switch
START
STOP
INLET
SELECT
PRIME
TEMP
RPM
FLOW RATE MODE
DISPLAY
SHOWS
XXX mL/min
or
NOTE: if you turn off the pump motor's power, the pump stops
XXX L/min
To continue pumping, turn on the unit's power. The display
returns to the STOPPED Display Mode and shows the current
FLOW RATE setting. The accumulated time of pumping and
volume dispensed is reset to zero. Then press the START/STOP
key .
XXX mL/min
or
To start pumping at this setting, press the START/STOP key.
XXX L/min
The display enters the RUNNING Display Mode, and the fluid
begins to dispense.
Must STOP first!
To select the other inlet and reverse the direction of pumping:
1.
2.
3.
4.
STOP to Prime...
To prime a tube:
1.
2.
3.
4.
xxx °C
NOTE: The TEMP key functions the same whether the pump is
xxx rpm
Press the RPM key. The display flashes the actual pump motor
speed (xxx rpm).
ACTION TAKEN
AND PROCEDURE
Pump motor's power
running.
Pump(s) starts; press again pump(s) stops
LEDs indicate new pump direction
Press the START/STOP key. The display returns to the
STOPPED Display Mode.
Press the INLET SELECT key to reverse the direction of
pumping.
Press the START/STOP key again to resume pumping.
For detailed instructions on "Defining the Direction of
Pumping, refer to Section 5.2.
Pumps fluid at current flow rate
setting as long as the key is pressed
Press the START/STOP key to stop the pump. The display
returns to the STOPPED Display Mode.
Press and hold down the PRIME key to prime the tube.
Press the START/STOP key again to resume pumping.
For detailed instructions on "Priming a Tube", refer to
Section 5.4.
Display alternates when pressed, °C then °F
stopped or running. Refer to Section 5.6.
Displays actual RPM
6-9
Advertisement
Table of Contents
