Table of Contents
Advertisement
4
Turning on the Power
3.
4.4 The RUNNING Display Mode
To enter the RUNNING Display Mode, do the following:
1.
2.
4-2
Turn on the unit's power. You are now in the STOPPED Display Mode (refer
to Figure 4-1). The motor and the pump(s) are stopped. The display flashes,
indicating that the pump motor is waiting for you to do something. The non-
flashing, green LEDs indicate the tubing inlets (refer to Section 5.2), but fluid is
not flowing.
STOPPED
DISPLAY
MODE
Figure 4-1. STOPPED vs. RUNNING Display Modes
STOPPED
Display Mode
Figure 4-2. RUNNING Display Mode
From the STOPPED Display Mode, press the START/STOP key. You are
now in the RUNNING Display Mode. Refer to Figure 4-2. The pump
motor starts. The attached pump(s) begin pumping fluid. The display is not
flashing. The green LEDs flash and point to the tubing inlets.
Press the START/STOP key again. The pump motor stops. Fluid stops
dispensing. You return to the STOPPED Display Mode.
START
STOP
RUNNING
DISPLAY
MODE
START
STOP
START
STOP
Display
enters RUNNING Display Mode
ACTION
Pump(s) starts
Advertisement
Table of Contents
