Table of Contents
Advertisement
Table 6-1 (cont'd)
KEY
FLOW
RATE
TOTAL
VOLUME
TUBE ID
CALIBRATE
and
Language
Button
6-4
DISPLAY
SHOWS
xxx mL/min
or
Press the FLOW RATE key. The display flashes the fluid flow
xxx Liter/min
rate calculated for the RPM setting previously selected (xxx
mL/min or xxx L/min).
xxx mL
or
1.
xxx Liters
TUBE ID=xxx
Press the TUBE ID key. If the red LED next to the CALIBRATE
key is not lit, the display flashes the current TUBE ID setting. If
the red LED next to the CALIBRATE key is lit, the display flashes
the message "CALIBRATED TUBE!".
CALIBRATED!
or
not calibrated
1.
To calibrate a tube:
2.
NOTE: if you press the UP and DOWN ARROW keys, the dis-
xxx rpm
NOTE: if you press the Language button, the display changes to
RPM MODE
ACTION TAKEN
AND PROCEDURE
Displays actual FLOW RATE
Displays current TOTAL VOLUME
Press the TOTAL VOLUME key. The display flashes the
calculated volume of fluid dispensed since the pump started
running (xxx mL or xxx Liters).
Displays current TUBE ID
Displays calibration state
Press the CALIBRATE key. If the red LED next to the
CALIBRATE key is not lit, the display shows "not calibrat-
ed".. If the red LED next to the CALIBRATE key is lit, the
display shows "CALIBRATED!".
Press the START/STOP key to stop the pump. The display
returns to the STOPPED Display Mode. For detailed
instructions on "Calibrating a Tube", refer to Section 5.5.
play shows the current RPM setting. This setting
changes accordingly as you use the UP and DOWN
ARROW keys but does not wrap around at 10 RPM and
600 RPM while the pump is running. Refer to Figure 6-2.
the next language in the sequence: English, French,
Spanish, German, and Italian.
Advertisement
Table of Contents
